Installation manual

IOI-XTRK-10D Installation Manual

Configuring Camera Settings via the Encoder 5.3

The encoder’s web interface is used to configure the CP-2202-361P/N camera.

To configure the camera

1. From the Setup window, select Camera > Type & Model.

Figure 11 - Type & Model Setup Window

2. Check Enable Re-arm. If the camera was previously armed, this function returns the

camera to Armed status after the user releases manual control of the camera.

3. From the Re-arm Duration drop-down list, select the duration of the re-arm period

(default 30 seconds). The Re-arm duration is the amount of time until the camera

returns to Armed status after the user releases the camera from manual control.

4. Check Enable Digital Zoom. This function enables increasing the CP-2202-361P/N

camera’s 36x optical zoom by up to four times (up to 144x).

5. Click Start PTZ Setup and follow instructions in the XPVA-10D/100D Installation Guide.

6. On the control keypad, click Menu. The camera’s On-Screen Display opens.

7. Start configuring camera settings by following instructions in the CP-2202-361P/N User

and Installation Guide.

Resetting the Encoder 5.4

There are two ways to reset the IOI-XTRK-10D:

 Reset Using the RESET Button

 Reset by Removing the Power Supply

5.4.1 Reset Using the RESET Button

The IOI-XTRK-10D reset button is used to reset the unit. See Figure 3 - IOI-XTRK-10D Front Panel

(page 3).