Installation manual

Connections and Configuration

5 Connections and Configuration

Installation of the encoder requires several steps described in the following sections:

 Connecting the Encoder (page 13)

 Configuring the Encoder’s Network IP Settings (page 19)

 Configuring Camera Settings via the Encoder (page 20)

 Resetting the Encoder (page 20)

 Solo Setup (page 21)

Connecting the Encoder 5.1

This section contains the following topics:

 Connecting the Camera to the Encoder (page 14)

 Connecting the Unit to Control an External Device (Using Relay Outputs) (page 15)

 Connecting the Encoder’s Video Output to an Analog Device (page 17)

 Connecting a Microphone to the Unit (page 17)

 Connecting a Loudspeaker to the Unit (page 18)

 Grounding the Unit (page 18)

 Connecting the Unit to the Power Supply (page 19)

 Connecting the Encoder to the Network (page 19)