Installation manual

IOI-XTRK-10D Installation Manual

3 Workflows

The following are general workflows for installation as well as pre- and post-installation steps. The

workflows are only guidelines. Individual installation may require variations based on the needs of

the site.

This section contains the following sections:

 Pre-Installation Workflow

 Installation Workflow

 Post-Installation

Pre-Installation Workflow 3.1

 Install electrical infrastructure (conduit, electrical wiring, boxes, breakers,

grounded outlets, switches, UPS, surge protector, grounds, etc.).

 Establish or install LAN/WAN network access for unit location (network

wiring, ports, wireless, Wireless Access Points, etc.).

 Install wiring between interfaces to external devices (relay outputs) and the

unit location.

 Install wiring for audio input and output devices (microphone/audio system)

and the unit location.

 Install video monitors and the wiring to connect to the unit location.

 Install wiring between PTZ controller leads and the unit location.

 Connect the workstation computer to the network.

Tip:

1. The unit is delivered from manufacture with a pre-configured IP address.

Change the pre-configured IP address to match your network IP mapping

before connecting the unit to the network.

2. It is possible to access the HTML setup menu in the unit by connecting from

a laptop/PC directly to the unit using a network cable and typing the IP

address in a web browser (32-bit version of Internet Explorer 8 or 9 only).