Installation manual

Introduction
3
Hardware Overview 2.2
This section provides a short description of the IOI-XTRK-10D front panel connections and features.
Figure 3 - IOI-XTRK-10D Front Panel
#
Feature
Description
1
Terminal
block port 1
The terminal block includes:
 Inputs for connecting the RS485 control wires between the camera and
the encoder (T+ and T-).
 Additional ground connection.
2
ETHERNET
802.3af PoE
port
Port for connecting a PoE injector or an Ethernet cable to a 10/100 Mbps
Ethernet Local Area Network.
3
AUDIO
IN/OUT
(Plug)
3.5 mm stereo audio interface to/from the unit. The plug requires a splitter
cable (supplied by DVTEL) to separate the audio input and output signals.
Enables remote listening to the sounds captured by a microphone connected
to the unit through this interface.
 Audio Input: Enables remote listening to the sounds captured by a
microphone connected to this plug on the IOI-XTRK-10D unit. See
Connecting a Microphone to the Unit (page 17).
 Audio Output: Enables talking to people near the camera being monitored
via an amplified loudspeaker that is connected to this plug on the
IOI-XTRK-10D unit. See Connecting a Loudspeaker to the Unit (page 18).
4
VIDEO IN
Video input for receiving analog video signal from the CP-2202-361P/N
camera.
5
RESET
Small opening that allows access to the RESET button. Resets the unit’s
internal firmware to the previous settings.
6
24V/12-24
The power outlet for plugging in (terminal block connection) the power from
a properly rated power source.