User manual

43
Interface mode:
Select the desired protocol for the serial interface.
Half-duplex mode:
Choose the setting appropriate for your application.
Network settings
The settings on this page are used to integrate the unit into an existing network.
Note
Although the modified network settings are copied to the 7700 Series unit when the Set button is clicked,
they become effective only after the unit has been restarted. To restart the unit, click the “Reboot”
link indicated above.
Unit IP address:
Enter the desired IP address for the 7700 Series unit in this field. The IP address must be recognized by the
network.
Subnet mask:
Enter the corresponding subnet mask here if the unit is to communicate via a subnet.
Gateway IP address:
Enter the corresponding IP address here if the unit is to establish a connection outside the local network
independently. Otherwise, this field can remain empty (0.0.0.0).
Video/Audio transmission:
If the device is used in front of a firewall, TCP (Port 80) should be selected as the transmission protocol. For
use in a local network, choose UDP.
Warning!
Multicast operation is possible only with the UDP protocol. The TCP protocol does not support multicast
connections.
Click this link
to reboot unit