User manual
26
Alarm IP address:
Enter the IP address of the device with which a connection is to be established in the event of an alarm.
Remote password:
Enter the password for the remote device (if it has one) that is to be contacted in response to an alarm.
Live video auto-connect:
Select On here if an active connection should be established after each reboot, for example following a
connection failure or power failure.
Motion detector
The 7700 Series unit contains an integrated video sensor that can register changes in the video signal based
on image processing. These changes are triggered primarily by any movement that is detected in the camera's
field of view.
The sensitivity of the video sensor can be adjusted, so that an alarm is generated only if a given threshold is
exceeded.
In order for the sensor to function, the following conditions must be satisfied:
• The motion detector must be enabled.
• At least one cell must be activated.
• Individual parameters must be configured correctly to suit the operating environment and the responses
desired.
• The sensitivity must be set to a value greater than zero.
Warning!
Changes in lighting conditions can spuriously trigger the video sensor and generate false alarms.
Perform sufficient tests during the day and night in order to ensure correct operation of the video sensor.
When the system is used for surveillance of indoor areas, ensure constant lighting during the day and at
night. Uniform surfaces without contrast can trigger false alarms even when light levels are constant.
Note
Clicking the Defaults button will reset the video sensor to its factory configuration.