User manual

17
General procedure
The screens for the Installation Wizard will be shown in sequence, allowing you to work quickly and easily. The
upper part of the window always contains information about the settings options. The current settings are
shown in the lower part of the window. You can change settings by entering the desired value in a text field or
choosing it from a list. The navigation buttons for the Installation Wizard are at the bottom of the window. You
can switch between pages of the Wizard at any time.
– Read the information provided.
– Make the desired settings changes.
– Click Next>> to proceed to the next screen.
or
– Click <<Back to return to the previous screen.
or
– Click Cancel to end the wizard without changing the settings.
Finishing the configuration
After you have gone through all the wizard’s screens, the changes must be transmitted to the unit and saved.
Click Finish in the last screen of the Installation Wizard to complete this process.
Warning!
All settings changes will become effective only after you have ended the configuration by clicking Finish
in the last screen.
– Go to the last screen of the Installation Wizard if necessary.
– Click Finish to finalize the configuration. All settings will be transmitted to the 7700 Series unit and become
effective forthwith.
Configuration with the Configurator
The Configurator allows all parameters of the 7700 Series unit to be changed. You can view the current
settings by opening one of the configuration pages. The settings can be changed by entering new values or
by selecting predefined values from drop-down menus.