User guide

5-2
VENICE Client Software User Guide
5.1 Controls Available for a Transcoding
This section describes shortly the controls and settings items that are
available for a transcoding exclusively. The remaining items can be used
the same way as already described for the playout and ingest mode (see
chapter “Playing Out Clips” on page 3-1 and chapter “Recording
Clips” on page 4-1).
5.1.1 Configuration Items
As with the other operation modes, before a transcoding can be per-
formed you have to set up the operation (see also section “Configuring
the Operation Mode” on page 2-6). It has to be performed same way
as for the playout or ingest mode. This section describes the settings
items that are available for a transcoding exclusively.
Source
With the source settings you determine the clips that should be
transcoded/converted.
Output select
These items set the essences that should be converted to the other file
format.
Output settings
With these settings you set the file format that the selected clips should
be converted to:
Use the Target resolution setting to configure the video raster that
the target video clip should provide.
This button appends the clips that are selected in
the entry fields to the left to a transcoding list. If
video and audio are both available, they will ap-
pear as linked items in the list. With only a single
item selected, only this item will be added to the
list.
Inserts the clips that are selected in the entry fields
to the left in the transcoding list above the item
that is currently selected in the list. If video and au-
dio are both available, they will appear as linked
items in the list. With only a single item selected,
only this item will be added to the list.