User guide

3-16
VENICE Client Software User Guide
The buttons IN and OUT enable you to set an in-/
outpoint directly from the position currently indi-
cated in the position field. Move via the position
field or the other controls to the position that you
want to set. Then press the respective button and
the entry field to its right will take on the selected
position. The entry field for the duration will be set
accordingly as well.
After entering a particular position/duration in one
of the entry fields to the right of the IN, OUT and/
or DUR button and pressing [Enter] the respective
in-/outpoint or duration for the operation will be
set.
Whether the inpoint or outpoint should
be changed when altering the duration
can be set in the VENICE configurations
(see “VENICE Administration and Config-
uration” user guide).
With the smaller GO buttons you can move to the
associated point (in- or outpoint). When entering a
new position in one of the entry fields to the left
and afterwards pressing the respective GO button
to the right, the in-/outpoint will be set accordingly
and a goto procedure will be performed to the new
position.
These buttons are toggle buttons that mark the re-
spective in-/outpoint or duration for a deletion
(when activating it for the duration, the button
DUR will be made available). After clicking on the
associated IN, OUT or DUR button, the in-/out-
point or duration will be deleted and set back to its
default value.
Shows the elapsed and remaining time of the item
to be played out, recorded, etc.
The position field shows the current position on the
timeline during a play-out/record operation. The
field can also be used to move to a certain position
by entering it in this field and afterwards pressing
[Enter] or the larger GO button.
With this combo box you can switch the notation
of the position and length indicators for the cur-
rently activated controls between timecode and
frames (see also section “Switching the Notation”
on page 2-17).