Specifications

5-13
Maintenance
2
1
3
I
4
A
5
5.5 Removal of the Faceplate
The faceplate of the system can be removed, for example, for trans-
ports. For this perform the following:
 Fold down the faceplate of the system (see section “The Front of
the System” on page 2-4).
 Then pull the faceplate as far as its hinge brackets are pulled out of
their guide rails up to the anchoring element. This is indicated in the
following figure:
Figure 5-5: Removing the hinge brackets
The hinge brackets will be loosened so that they can be removed from
their holders at the rack-mount ears. Afterwards the faceplate can be
taken off with its hinge brackets.
The system must be operated only with the faceplate installed
to ensure electromagnetic compatibility.
To reassemble the faceplate reverse the above steps.