Specifications

4-1
4
4
2
1
3
I
5
A
Operation
This chapter describes how to operate the VENICE 2U/Element hard-
ware. It is explained how to start the system and how to shut it down.
For both procedures you have to use the power switch within the op-
eration items at the front of the system.
Figure 4-1: The power switch
4.1 Starting the System
After a proper installation of the system (see chapter “Installation” on
page 3-1) you may start the DVS system at any time.
To start the system perform the following:
 Press the power switch briefly to turn on the system.
The system will be started and after closing the faceplate the DVS logo
in the middle of the faceplate lights up. As with any standard computer
after initial booting, the system begins to load the installed operating
All other items necessary for a correct operation of the
VENICE 2U/Element hardware, such as the LEDs of the hard
disk array or the reset button, are described in section “Opera-
tion Items” on page 2-6.
power switch