Specifications

3-1
3
3
2
1
I
4
5
A
Installation
This chapter describes the installation procedure of the
VENICE 2U/Element hardware. The system must be installed properly
before you can start working with it.
To install the hardware of VENICE 2U/Element perform the following:
 Unpack the DVS system and its accessories.
 Place the DVS system on a firm, flat surface within reach of a power
outlet or mount it in a rack. For good air circulation and cooling
make sure the ventilation holes are not covered.
 Connect at least the following computer peripherals:
–Mouse,
– keyboard and
– a monitor that is operable at a resolution of at least
1280 × 1024 pixels (default manufacturing setting).
 Connect any other peripheral computer and video equipment. For
an overview of the panels and connectors at the system’s rear see
section “Overview of the Rear” on page 2-10.
 Connect the power cable(s) to the system.
The VENICE 2U/Element hardware is now properly installed and you
can switch on the system as described in section “Starting the System”
on page 4-1.
Check your delivery and compare it with the delivery note in-
cluded in the package on an extra sheet of paper. In case of
missing items, please contact your local vendor or DVS imme-
diately.
To make warranty claims you have to keep the original pack-
ing and use it in case of a return transportation.
After installing the hardware the DVS system has to be set up
first before it can be used. How to perform the initial setup is
described in detail in the software documentation delivered
with the system.