User guide

5-27
2
1
3
5
4
6
7
Capturing Clips
I
A
5.4 RS-422 Recording (Autoedit Mode)
After switching to the Autoedit record mode you can
perform a record from an external player connected
via remote (RS-422), such as a VTR: You can record a clip from a certain
inpoint to a certain outpoint or duration of the video material. As soon
as the record operation is started, the external player will go to its pre-
roll position and start playing from there. When the inpoint is reached,
the I/O Tool performs the record up to the point of the set out-
point/duration. Then the clip has been captured according to your set-
tings and saved directly on the storage. Furthermore, a thumbnail of
the recorded clip will be available in the contents area of the bin.
This section explains in detail the further settings that are available in
this mode. After that it is described how to perform a record and thus
how to use this mode.
5.4.1 Further Settings
After clicking on the button AUTOEDIT in the I/O Tool the Autoedit
record mode is activated and the selection area to the right of the task
mode buttons changes its appearance. Then you can see the settings
items that are necessary for this mode:
Figure 5-13: Selection area of Autoedit mode
In the selection area for the Autoedit record mode you can find next to
the items for the general settings (see section “General Settings” on
page 5-4) the settings to control a record operation via RS-422:
Figure 5-14: Specifications for an RS-422 record
With the In, Out and Dur items you can control the position on the ex-
ternally connected player for the record of a clip. When two of the three
items are determined, the remaining item will set itself accordingly and
you can start a record operation. Then the external player will be com-