User guide

5-21
2
1
3
5
4
6
7
Capturing Clips
I
A
5.3 Crash Record (Manual Mode)
With the I/O Tool in the Manual record mode you can
perform a simple crash record. After specifying the
general settings you can start a record operation at any time either
completely manually or with a set record duration. In this mode it is also
possible to control the DVS system by remote and send a record com-
mand to the I/O Tool via RS-422. When a record is performed, the
I/O Tool will record the incoming signal according to your settings and
save the clip on the storage. After the operation is finished, a thumbnail
of the recorded clip will be available in the contents area of the bin.
This section explains in detail the further settings that are available in
this mode. After that it is described how to perform a crash record and
thus how to use this mode.
5.3.1 Further Settings
After clicking on the button MANUAL in the I/O Tool the Manual record
mode is activated and the selection area to the right of the task mode
buttons changes its appearance. Then you can see the settings items
that are provided for this mode.
The following figure shows the selection area with the Manual record
mode activated:
Figure 5-11: Selection area of Manual mode
In the selection area for the Manual record mode you can find next to
the items for the general settings (see section “General Settings” on
page 5-4) the following items:
By default, the Manual record mode is automatically active af-
ter starting the I/O Tool (see section “Starting the Program”
on page 2-4).