User guide

5-8
CLIPSTER I/O Tool User Guide
Via the combo box Sampling choose the sampling rate that the audio
data shall be recorded with.
To configure the I/O Tool to your settings you have to confirm them
with the OK button. The button CANCEL will close the ’Audio input’
window without altering the settings.
5.2.3 Setting of a Record Type
With the setting of the record type you select the type of material that
you want to capture. You can choose whether you want to record audio
or video alone, or both together.
In case you want to capture video, you have to activate the button
VIDEO ( ). You can find this button directly below
the button to configure the audio format.
Figure 5-5: Buttons to set the record type
To set the I/O Tool to a record for audio you have to use the channel
buttons below the button VIDEO.
The channel buttons represent the 16 audio channels provided by the
DVS system. If (as in the screenshot above) channels 1 and 2 are select-
ed, the I/O Tool will record the audio signals that are present at these
channels.
With a click on the respective button select the digital audio channel(s)
that should be recorded. An activated + button between two channels
configures them as stereo channels. If the + button is deactivated the
respective channels will be recorded as mono channels. You can also se-
lect/deselect all channels in a single step via the context menu of the
audio channel buttons:
To record either video or audio a correct signal has to be con-
nected to the inputs of the hardware. Otherwise an error mes-
sage will be displayed. Furthermore, for the capturing of audio
alone a video signal has to be present at the system’s input(s)
and the video format (see section “The Video Format” on
page 5-4) has to be set accordingly.