User guide

4-4
CLIPSTER I/O Tool User Guide
formation groups as well as all other items available in the information
area are described in the following:
The Group ’Video’
The group Video provides detailed information about the video signals
currently present at the inputs:
The Group ’Audio’
If audio signals are connected to the system’s inputs, you will receive
further information about them via the entries sorted under this group:
SDI A Shows the video raster and frame rate of the
signal present at the input port A of the serial
digital interface (SDI In A).
SDI B Displays the video raster and frame rate of the
signal present at the input port B of the serial
digital interface (SDI In B).
Mode Details the color space and bit depth set for an
input, i.e. the setting of the input video format.
Genlock Shows the video raster and frame rate present at
the reference input connector of the DVS sys-
tem (REF In or H/S In).
VITC lines Indicates the lines of the incoming video data
where the vertical interval timecode is transmit-
ted. VITC is usually transmitted in PAL and
NTSC video rasters in up to two lines.
The output of VITC can be configured
freely with the Configuration Tool (see
“CLIPSTER Configurations” user
guide).
Sync Shows the state of the synchronization (locked
or unlocked). Via the input video format set-
tings you can determine the reference that
should be used for a synchronization (see sec-
tion “The Video Format” on page 5-4 and sec-
tion “The Video Format” on page 7-17).
AIV If the audio signal is embedded in the video sig-
nal, this entry will show you the channels trans-
mitted via the video signal.
AES As soon as an audio signal is connected to the
digital audio inputs, this field shows you the
channels present at the inputs.