User guide

7-22
CLIPSTER I/O Tool User Guide
To deselect a previously selected processing type you have to click the
respective button again.
7.2.4 The VTR Timeline and Its Controls
The VTR timeline’s representation in the selection area of the VTR task
mode shows you either the full 24 hours provided by the timeline or a
zoomed into part of the timeline (timeline between in- and outpoint)
depending on the selected viewing mode.
With the controls below the timeline’s representation you can control
the timeline as well as configure its viewing mode.
Figure 7-15: VTR timeline area
The items provided by the VTR timeline and its controls are explained
in the following.
The VTR Timeline
The VTR timeline’s representation in the selection area of the VTR task
mode shows you either the full 24 hours provided by the timeline or a
zoomed into part of the timeline (timeline between in- and outpoint)
depending on the selected viewing mode:
Figure 7-16: VTR timeline
You can use the VTR timeline to move within your project or configure
its in- or outpoint. Furthermore, it provides several features such as dif-
Regarding audio files the VTR mode uses sparse files that re-
serve the amount of data which can be recorded with audio in
this subdirectory, even if it has not been recorded already. The
maximum amount of data up to the latest captured audio out-
point will already be available in the audio files.
Further information about audio and the way it is handled in
the I/O Tool can be found in section “Audio in the I/O Tool”
on page 2-9.