User guide

7-19
2
1
3
4
The VTR Task Mode
I
A
6
5
7
Figure 7-11: Window to set the video format for the VTR timeline
As a standard after selecting the video format settings the SDI output
configurations are displayed. With the tabs at the very top you can
switch through the in- and output settings for the different ports. Use
the items provided on the selected tab to set the respective format.
On the tab VTR out you can also set the amount of audio channels that
will be embedded in the outgoing video signal (AIV). This is provided
because some external devices have difficulties when handling embed-
ded audio that provides more than four audio channels.
As soon as the settings are confirmed with the OK button, they will be
in effect. All ports of the DVS system (except the SD outputs) will
change their format respectively. Depending on the selected output
video format for SDI the video overlay of the I/O Tool may change its
Further information about audio and the way it is handled in
the I/O Tool can be found in section “Audio in the I/O Tool”
on page 2-9.
Additional information regarding the video formats for in- and
output can be found in section “Video Format Settings for In-
and Output” on page 7-15.
The description of the window to configure the video format is
not part of this user guide. It is in detail described in the “CLIP-
STER Configurations” user guide.