User guide

6-16
CLIPSTER I/O Tool User Guide
y Specify the video format settings for the output as detailed in sec-
tion “The Video Format” on page 6-2.
y Then activate the button SLAVE.
The ’Slave mode’ control window appears on the screen.
y If necessary specify further details about the play-out of the time-
line there, such as an in- or outpoint of the timeline. For further
details about how to operate this window see the “CLIPSTER Edit
Tool” user guide.
After this the I/O Tool waits for a play-out command via RS-422 to be-
gin a play-out of the timeline of the Edit Tool.
To stop the slave mode play-out perform the following:
y Either send the respective command via RS-422 or stop the play-
out by deactivating the play button in the ’Slave mode’ control
window. You may also terminate the slave mode of the I/O Tool
completely by clicking on the CLOSE button.
The I/O Tool then stops the slave mode play-out of the timeline of the
Edit Tool.
All other settings of the selection area have no effect on a play-
out via slave mode.