User guide

5-61
2
1
3
5
4
6
7
Capturing Clips
I
A
y After this switch to the matrix settings via the tab Matrix in the tool
area of the I/O Tool.
The tool area of the I/O Tool changes its appearance and the matrix ta-
ble is displayed with its current settings. Via the matrix settings you
have to determine the location of the video material as well as config-
ure timecode related settings for the conforming process.
y Take a look at the following table and configure the matrix table to
the settings appropriate for your conforming process. Alter the set-
tings available in the matrix table accordingly:
On most of the settings fields you can call up a context menu
which provides the menu option Set all. This will transfer the
respective setting where the context menu has been invoked
to all other fields in the same column.
When using the Source TC settings with VTR-Project, field
Path must point to the VTR timeline project file. Then the soft-
ware will find the respective material automatically.
Table 5-2: Settings for a conforming
Column Setting Description
Reel ./. Can only be altered by adapting the
capture list, EDL or cut list manually
(see section “Preparing a Batch” on
page 5-53), or by selecting each
entry of this reel individually in the
capture list and altering its reel
name in the selection area (button
MODIFY, see section “Further Set-
tings” on page 5-51).
To avoid conflicts due to identical source time-
codes/keycodes the reel names stored in file
headers can be checked. Further information
about this can be found in section “Trouble-
shooting a Conforming Process” on page 5-65.
Source Disk Online This setting searches in the speci-
fied location (Path) for the clip(s).
VTR-Project This setting uses a VTR timeline
project (see chapter “The VTR Task
Mode” on page 7-1) for the on-
line-conforming process. The path
and file name of the VTR timeline
project has to be stated in the fields
of the column Path.