User guide

5-59
2
1
3
5
4
6
7
Capturing Clips
I
A
y If desired, enter the appropriate information in the fields Project
name and Slate information. The entered information will be
written to the file headers of *.dpx image files.
y After that press the RECORD button to the right of the selection
area to start the record operation.
The I/O Tool then performs the record of the batch (capture list) from
an externally connected player: If not already active, the control area
switches to the RS-422 mode automatically to show the input signal in
the video overlay (as it will be available at the outputs of the DVS sys-
tem). For each clip to be recorded the external player will go to its pre-
roll position and start playing from there. When the respective inpoint
is reached, a record is performed by the I/O Tool up to the point of the
outpoint stated in the capture list. Then the record will be terminated
and a thumbnail of the recorded clip will be added to the contents area
of the bin. After that the I/O Tool will send the commands for the next
clip to be recorded. During the records the numbers of the Rec field in
Table 5-1: Settings for an RS-422 record
Column Setting Description
Reel ./. Can only be altered by adapting the capture
list, EDL or cut list manually (see section
“Preparing a Batch” on page 5-53), or by
selecting each entry of this reel individually
in the capture list and altering its reel name
in the selection area (button MODIFY, see
section “Further Settings” on page 5-51).
Source VTR This setting enables a record via RS-422.
Additional information about the individual settings can be
found in section “The Tab ’Matrix’” on page 5-46.
The table of the capture list can be sorted to avoid unnecessary
cueing times of the connected external player. Further infor-
mation about this can be found in section “Further Features of
the Tab ’Capture’” on page 5-43.