User guide

5-52
CLIPSTER I/O Tool User Guide
Figure 5-28: Selection area of Batch mode
In the selection area for the Batch record mode you can find next to the
items for the general settings (see section “General Settings” on
page 5-4) the following items:
The items In, Out and Dur are the same as in
the Autoedit record mode of the I/O Tool. For a
description how to use them please refer to sec-
tion “Further Settings” on page 5-27. An exam-
ple of their usage is provided in section “How to
Use the Autoedit Record Mode” on page 5-29.
As soon as your specifications are complete (the
general settings as well as the setting of an in-
point, outpoint and duration with the items In,
Out and Dur), you can log them in the capture
list. The LOG button then adds a new row to the
capture list table and transfers the settings to it.
After this the settings will be displayed in the
capture list table of the tool area (see section
“The Tab ’Capture’” on page 5-33).
The L
OG button always writes data into
a new row of the capture list despite of
the number stated in the Pos. Nr. field.
The Pos. Nr. field is a self-incrementing number
that states the row number (entry) of the cap-
ture list table where the selections will be trans-
ferred to. When clicking on the M
ODIFY button,
the respective settings of the selection area will
be written to the stated position in the capture
list table.
When you select an entry in the table of
the capture list directly with the mouse,
the row number of the selected entry
will be set in this field as well.