User guide

5-50
CLIPSTER I/O Tool User Guide
File Number This setting is only available for Disk
Online and performs the same as the
the Source TC setting, only that it
uses the frame numbers provided by
the file names instead of the source
timecode. During the search, the file
numbers of the found clips will be
mapped to the timecode information
stated in the capture list, i.e. to the
source in- or outpoints. If necessary,
you can adjust the timecodes of the
capture list with the setting TC Offset.
The search behavior of the source timecode,
keycode and file number conforming methods
(i.e. the number of directory levels searched)
can be altered via the Configuration Tool (see
“CLIPSTER Configurations” user guide for fur-
ther information).
Path When Disk Online or VTR-Project is selected as a
source, you have to enter the search location where the
I/O Tool can find the respective clip(s) in this column. To
enter a directory path or VTR timeline project you may
also use the button to the right of this field ( ) and se-
lect one via the opening dialog window.
In case Disk Online is selected only the directory path
has to be entered where the I/O Tool can find the re-
spective clip(s). In this mode you may also use a special
conforming via the button ROOTDIR (see section “The
Buttons” on page 5-46).
With VTR-Project activated you have to select a VTR
timeline project file directly (file extension *.cp) that
will then automatically point to the correct location of
the clips for this VTR project.