Specifications

2-19
Overview
2
1
3
4
5
I
A
VGA
The on-board graphic card of the motherboard may not be sufficient to
handle digital video. Then the system will be equipped with an addi-
tional graphic card. The VGA panel is the panel of this graphic card. If
available, the monitor for CLIPSTER has to be connected here.
For further information about the graphic card, please refer to the orig-
inal manufacturer’s documentation included in the delivery of CLIP-
STER.
Video I/O Panel
The video I/O panel of CLIPSTER holds two video interfaces (DMS-59
connectors) for an output of analog and digital video signals. They can
be connected to breakout cables that will then provide each two stan-
dard DVI connectors. The breakout cables are included in the delivery
of CLIPSTER. Pin-outs of the DMS-59 and DVI connectors can be
found in section “Signal In- and Outputs” on page A-9.
The layout of the slot panel area on your system may differ
from the figure above: The position of the individual slot panels
may vary and additional panels may be installed for internal
reasons or on customer request.
If the VGA panel is present in your system, the VGA connector
available on the ATX connector panel will not be operational
(see chapter “ATX Connector Panel” on page 2-17).