Specifications

2-4
CLIPSTER Hardware Guide
2.2.2 Operation Items
With the operation items at the system’s front the hardware of CLIP-
STER can be controlled (e.g. turned on or off). There you can also find
LEDs that allow you to assess the state of the system as well as USB
connectors.
Figure 2-2: Operation items overview
The LEDs can be seen only when they are flashing because
they are located behind the white strip and thus not visible
when off.
Further information about what to do in case of an alarm can
be found in section “Troubleshooting” on page A-2.
No. Item Explanation
1 system HDD Indicates accesses to the system hard disk (e.g.
during the loading of the operating system).
2 alarm LED This LED indicates that a hardware malfunction
occurred.
3, 4 LAN 1/2 LEDs Indicate that a valid network is connected to the
first/second LAN connection at the rear of the
system (see section “ATX Connector Panel” on
page 2-17).
1 324 5 6
7 8 9
4U chassis:
3 24198
5 6 7
5U chassis: