User guide

5-13
Manual Creation of a DCP
5.4 Creating Additional KDMs Manually
With an already encrypted DCP and a self KDM you are able to create
further KDMs, for example, for later releases of the same material with-
out having to generate the DCP again. For this perform the following:
 Load the encrypted DCP as described in section “Loading the DCP”
on page 4-3.
 Then call up the finalize dialog of the DVS software (menu
Project » Finalize…).
 Next choose a name and storage location for the KDM(s).
Figure 5-13: File name and storage location
 Activate the finalizing of video with the check box Video output.
With a DCP loaded via a self KDM, you will get in the list of file formats
(combo box File format) an additional entry named DC KDM.
 As the file format select DC KDM.
 Afterwards click on the KEY… button.
This will open the window to configure the KDM generation (see sec-
tion “Finalize Settings – KDM” on page 5-10).
 In this window configure the generation of the additional KDM(s)
(see section “KDM” on page 3-18). However, because a self KDM
for the current DCP is already available, you may deactivate the
check box Create a KDM for current Clipster.
 When everything is set as desired click the OK button.
This will close the window to configure the KDM(s) and you will be re-
turned to the finalize dialog.
 In the finalize dialog make sure that the check box in front of the
KEY… button is activated, otherwise the KDM(s) will not be cre-
ated.
After this the settings to create additional KDM(s) are finished and you
can start their creation at any time:
 Press the button R
ENDER to start the creation of the additional
KDM(s).
This will start the creation and the additional KDM(s) will be written to
the specified location.