User guide

5-11
Manual Creation of a DCP
 In this window set the generation of the KDM(s) according to your
needs.
 When everything is set as desired click the OK button.
This will close the window to configure the KDM(s) and you will be re-
turned to the finalize dialog.
 In the finalize dialog make sure that the check box in front of the
KEY… button is activated, otherwise an encryption will not be
made and KDM(s) will not be created.
With this the KDM(s) will be created during the finalizing and you can
continue the configuration of the finalizing by finishing it (see section
“Further Finalize Settings and Rendering” on page 5-11).
5.3.5 Further Finalize Settings and Rendering
Via the remaining finalize settings you can determine the digital cinema
content that should be created further:
 In case your source data provides 3D material or subtitles use the
Stereoscopic output and the Subtitle output settings items and
configure them accordingly.
Afterwards only the audio settings remain to be set:
 If necessary enable the output of audio.
 In case it is not already set select DC MXF as the file format.
This will automatically configure the fields Bit depth and Render au-
dio in to the correct settings for a DCP.
 Use the remaining settings items to configure the audio output to
the needs of your DCP (see also section “Delivery Format” on
page 3-13).
These settings items are identical to the ones used in the dig-
ital cinema delivery tool. For further information about them
see section “KDM” on page 3-18.
For details about 3D and the Stereoscopic output item re-
fer to section “Stereoscopic DCP” on page 6-2 as well as
the “CLIPSTER 3D/Stereoscopy” supplement user guide.
Further information about the Subtitle output items can be
found in section “Delivery Format” on page 3-13.