User guide

2-26
Getting Started
 Configure these settings according to your requirements:
– Use the area Self KDM with the field Certificate to select the
public key of a DVS DCI Mastering system that should be able
to load the DCP, e.g. for quality checks. This public key will
then be used during the creation of a DCP to generate a special
KDM file (the self KDM). With this KDM you will be able to
load the DCP on the respective DCI Mastering system (e.g. to
view it, to create additional KDMs of the same DCP at a later
time, or to modify it). Select the file (*.cer) that holds the
public key of this DCI Mastering system with the button to
the right of the field Certificate. For further information about
the usage of the self KDM as well as its creation see chapter
“Using the DCP and Self KDM” on page 4-1.
– Use the button on the right-
hand side of the field Private
Signing Key to select your own
private key file (*.pfx) that
should be used to sign the extra
files of the DCP (Signing Key). For this you may have to enter a
password to authenticate your usage of the private key. It will
be applied if the check box Use System Signing Key is deac-
tivated. For further information about the Signing Key see sec-
tion “Signing Key” on page 6-12.
– By activating the check box Use System Signing Key you
can override the setting Private Signing Key. Then the DVS
system will use a system specific Signing Key to sign the extra
files of the DCP. For further information about this see section
“Signing Key” on page 6-12.
–With the DCI Phase combo box you select the standard that
the DCP should be created in. Further information about this
can be found in section “DCP Standards” on page 2-6.
– Activate the check box Use UUID in CPL name to get a
shorter version for the file name of the CPL based on its UUID
(universally unique identifier, file name syntax will be
CPL_<UUID>.xml). If deactivated, the file name of the DCP
will be used.
This public key file can be found either already stored in
the installation directory of the CLIPSTER software on
the respective system or on a separate CD-ROM.
Your authentication for the private key will be valid for
this session of the software only. After a restart of the
DVS software and when performing a DCI Mastering
again, you will be asked automatically by the software
to enter the password once more.