User guide

2-25
Getting Started
2.5 Configuring the System for a DCP Creation
For the creation of a DCP you have to make some general settings on
the tab Defaults of the Configuration Tool of the DVS software and
set, for example, the private key to sign the extra files of the DCP (i.e.
CPL, KDMs and PKL).
Because the settings on the tab Defaults are general settings for the
CLIPSTER software, they will be set and available for each initialized
new project. This way you do not have to configure them again when
creating other DCPs in the future:
 Open the DCI settings in the CLIPSTER Configuration Tool (menu
Options » Configuration defaults… » group DCI).
Figure 2-15: DCI configuration settings
These settings are not required in case you want to create an
intermediate step towards a DCP. They are applied during the
generation of a DCP only.
Further information about the keys and certificates used during
the creation and usage of a DCP can be found in section “Keys
and Certificates Explained” on page 6-11, and information
about the keys and certificates delivered with the DVS system
can be found in section “The Keys and Certificates Delivered
with CLIPSTER” on page 6-19.