User guide

2-20
Getting Started
 Configure the creation of the reels according to your requirements.
 Afterwards create the reels by clicking the OK button.
This will start the creation of the reels and when finished, you can see
them in the timeline area. After this they can be edited and configured
to your liking as described in section “Editing and Configuring the
Reels” on page 2-21.
2.4.2 Setting Reels Manually
The reels for a DCP can also be set manually. For this perform the fol-
lowing:
 If not already the case switch to the view of the DC reels by activat-
ing the toggle button IN/OUT/DC REELS of the timeline area.
When in the DC reels viewing mode, you can use the items to set the
timeline’s in- and outpoint to determine the DC reels. They can be used
in exactly the same way to set the in- and outpoints of the DC reels:
Figure 2-10: Items to set in- and outpoints
 Move the timeline cursor via its controls or manually to the position
where the reel’s inpoint should be set.
 Then press the button for the inpoint.
 Perform the same for the reel’s outpoint.
This will automatically create a DC reel in the timeline with the name
Reel name_<no.>. By performing the same procedure repeatedly
Set a DC reel …: Use this setting and its com-
bo box to specify that the video and/or audio
clips available in the timeline should determine
the reels. The reels’ in- and outpoints will then
be set at the edit points (cuts) of the clips.
Apply to This setting allows you to limit the procedure.
You can perform it either on all clips of the
timeline or on the clips of a timeline range only,
i.e. between a set in- and outpoint for the time-
line.
Item Description