User guide

9-16
CLIPSTER Edit Tool User Guide
The content (frames) to be copied is determined by the in- and out-
points of the clips on the timeline. With the Heads/Tails entry field you
can set the number of frames that should be copied in addition to these
for later heads or tails adjustments.
When everything is set, you can initiate the copying process with a click
on the button OK. Then the DVS high-speed copying process will copy
the files to the selected destination.
9.2.14 Load KDM…
The menu option Load KDM… is part of the optionally available DCI
Mastering feature of CLIPSTER. Further information about it can be
found in a separate document available via the online help of the soft-
ware (see section “Manuals” on page 9-27).
9.2.15 Exit
The menu option Exit ends the current Edit Tool session.
This closes the DVS software. After that you can, for example, shut
down the system.
To archive the whole project you have to save the project file
as well.
Further information about the DVS high-speed copying pro-
cess can be found in the “Spycer” user guide.
There is no way to end the Edit Tool alone. When you exit the
Edit Tool, the whole DVS software will shut down. Therefore,
it is recommended to finish all tasks, such as a record or a
play-out operation, beforehand. Otherwise the respective
task may get interrupted.