User guide

8-59
The Conforming Tool
2
1
3
4
5
6
7
8
I
A
9
plying this function again with different settings (i.e. they will be adjust-
ed, not doubled). This way they can also be removed from the timeline:
Either set them to a length of zero (0) or deactivate their check boxes.
After this the pre-/post-rolls will be removed from the timeline.
Update linking
With this button you can check the ’Online’ statuses of the EDL clips
(see section “The Tab ’EDL Clips’” on page 8-31), i.e. you can check if
the material that is linked to these clips is still available on the storage.
If inconsistencies are found, you will receive the following error mes-
sage:
Figure 8-40: Error message of inconsistencies in source material
The error message provides you with a detailed list of all clips that could
not be verified. Afterwards all inconsistent clips will be set to the status
’Offline’ and must be conformed again.