User guide

8-50
CLIPSTER Edit Tool User Guide
be displayed as after initiating an autoconforming (e.g. after the build-
up of an unconformed EDL in the timeline). For further information
about this window as well as about the autoconforming process see
section “Configuring the Autoconforming” on page 8-15.
Link data…
With this button you can start a conforming by using linking methods
that have been manually set for events, for example, on the tab EDL
Clips (see section “Conforming Mode – The Work Area” on
page 8-27). The linking data feature can be applied to either a selection
of unconformed events or all displayed on the tab EDL Clips. It is able
to perform different searches in a single step in accordance with your
settings, such as searching in the SpycerNet (SpycerNet) as well as on
the local storage (Disk Online).
A click on the button LINK DATA… opens the following window:
Figure 8-34: Linking data
When an autoconforming is performed, manually adjusted set-
tings for events (see section “Conforming Mode – The Work
Area” on page 8-27) may be overwritten with the ones set for
the autoconforming.
When Disk Online or VTR-TL is set as the ’Source type’, a
path has to be specified which can be done, for instance, in the
fields of the column ’Path’ on the tabs EDL Clips or EDL
Reels (see section “Conforming Mode – The Work Area” on
page 8-27).
When using this function the events set to VTR will be ignored.
For them you have to perform a capturing, for example, via the
button CAPTURE DATA… (see section “Capture data…” on
page 8-53).