User guide

8-49
The Conforming Tool
2
1
3
4
5
6
7
8
I
A
9
Figure 8-32: Slipping keycodes
This window provides you with the same possibilities as the window to
slip source in- and outpoints, only that it adjusts keycodes. For further
information about its settings items see section “Slip source TC…” on
page 8-47.
Accept changes
When changes were applied to an EDL, for example, by altering their
source or destination in- and outpoints, they will be displayed in orange
on the tab EDL Clips. By clicking this button you can accept the
changes. Then all entries in the table will be displayed in the standard
colors of unmodified events again.
8.6.4 The Execute Controls
The following describes the controls that allow you to process EDLs.
Figure 8-33: The execute controls
Autoconform…
This button starts an autoconforming process for the EDL that is cur-
rently selected in the work area. After pressing it the same window will
Only the keycodes’ reference numbers can be altered.
Further information about keycodes can be found in section
“About Keycode” on page 2-16.