User guide

8-48
CLIPSTER Edit Tool User Guide
To adjust the source in- and outpoints you can select between several
possibilities and you have to choose one with the radio buttons to the
left:
Additionally, once an option has been set, you can specify the range of
events that should be changed with the Apply to combo box: They can
be performed either on all clips of an EDL or the event(s) currently se-
lected in on the tab EDL Clips.
When everything is set, the source in- and outpoints of the EDL can be
adjusted by clicking the button OK. Afterward the adjusted source in-
and outpoints will be displayed in orange.
Slip source KC…
If keycodes are available in your EDL or cut list respectively, they can be
adjusted with this button in a single step. It opens the following win-
dow:
Further information about timecode or frames notation can be
found in section “About Timecode / Frame Number Fields” on
page 2-17.
The smallest/largest source in-/outpoint available among the
selected events cannot be set beyond the boundaries of a 24-
hours timeline.
combo box With this item you can set either a new source
inpoint or a new source outpoint. Select the re-
spective option from the drop-down list of the
combo box. Then enter in the field to the right
the new in- or outpoint in timecode format. If
more than one event will be altered, it sets the
source position of the smallest/largest value. All
other events will be adjusted accordingly.
Offset as frames Sets an offset value in frames (positive or nega-
tive) that will be added or subtracted from the
source in- and outpoints of the selected events.
Offset as
timecode
Sets an offset value in timecode format (positive
or negative) that will be added or subtracted
from the source in- and outpoints of the select-
ed events.