User guide

8-42
CLIPSTER Edit Tool User Guide
list shows all EDLs currently available in the project (see also section
“The Tab ’EDLs’” on page 8-29).
View settings…
Via the button VIEW SETTINGS… you can adjust the appearances of the
tables on the tabs of the work area to your needs. It allows you to hide
or display columns of the tables. Additionally, you can configure the
size of the thumbnails of the work area. A click on this button opens the
following window:
Figure 8-26: The view settings
With the buttons at the top of the window you can switch between the
different views (tabs) of the work area (see section “Conforming
Mode – The Work Area” on page 8-27). The items that are available
for each view will then be displayed below the buttons. By activating or
deactivating the check boxes you can display or hide columns in the ta-
bles of the tabs.
Furthermore, in some views of the work area you can also display
thumbnails of the EDL clips (see section “Text / Image” on page 8-43).
Then the settings items Size of thumbnails will be available at the
bottom of the window. With them you can adjust the width and height
of the thumbnails that can be displayed in the selected tab. Either enter
the size (in pixels) manually or use the controls to the right of the entry
field to step the value up or down until it is set as desired. When the
check box below the settings items is activated, you can adjust just one
value: The remaining value will adapt itself according to the entered