User guide

8-36
CLIPSTER Edit Tool User Guide
8.5.6 The Tab ’EDL Reels’
On the tab EDL Reels you can find the reels that are currently avail-
able in the selected EDL. It provides information, for example, about
their names and conforming methods.
Offset/Start frame When File number as TC is selected, you
can enter in this field a timecode/frames offset
for the respective event (negative as well as
positive). The entered offset will be added to
the source in- and outpoint.
When Start frame is selected, you can enter
in this field the frame number that should be
identified as the source inpoint, i.e. this frame
number will then be assigned to the position
stated in ’Source IN’ and taken as a reference to
calculate the remaining values.
In case this setting is made on the tab
EDL Reels for the reel of the event,
any manually specified value here will
be overwritten.
Path Details where to search for clips for this event.
If applicable, it is already set to the path that
was selected during an autoconforming (see
section “Conforming” on page 8-13). By
changing this entry you can select a new loca-
tion for the search when Disk Online or
VTR-TL is selected. For further information see
Video path and Audio path in section “Con-
figuring the Autoconforming” on page 8-15.
Consolidated clips Shows the name of the consolidated clip, i.e.
the (future) source clip for this event (see sec-
tion “Capture data…” on page 8-53).
Bin clip Details the path and name to this event in the
bin of the DVS software.
Comment If applicable, this field shows comments that
were available for this event in the originally im-
ported EDL file. It can be changed freely, i.e.
you can change already available comments or
enter new ones. When exporting to an EDL, the
entries in this field will be added as comment(s)
for this event to the exported EDL.
Column Description