User guide

8-35
The Conforming Tool
2
1
3
4
5
6
7
8
I
A
9
VTR Records the event via RS-422
from an externally connected
player (see section “Capture
data…” on page 8-53).
None This event is ignored during a
conforming.
When an autoconforming is performed
for this event, a manually adjusted set-
ting will be overwritten with the one of
the autoconforming.
Search criteria Details the search criteria that was selected dur-
ing an autoconforming (see section “Conform-
ing” on page 8-13). It is the same setting as the
Source criteria setting of the autoconforming
dialog. By changing this entry you can change
what should be searched for. Depending on the
selected ’Source type’, this field either cannot
be edited at all or provides different settings
possibilities. Then, in addition to the settings al-
ready described in section “Configuring the Au-
toconforming” on page 8-15 you can select
here the following:
Start frame This setting is similar to File
number as TC. You can use
it if there is no direct connec-
tion between file numbers and
EDL timecodes. With this set-
ting you can specify a start
frame number that should be
identified as the source inpoint
(see below). The actual search
will be performed as with
File number as TC.
This setting can also be made on the
tab EDL Reels. There you can assign a
start frame number for a complete reel
(see section “The Tab ’EDL Reels’” on
page 8-36).
When an autoconforming is performed
for this event, a manually adjusted set-
ting will be overwritten with the one of
the autoconforming.
Column Description