User guide

8-34
CLIPSTER Edit Tool User Guide
Keycode IN
Keycode OUT
These entries show the keycode in- and out-
point. Normally these information are detailed
in cut lists only. When available, they can be
changed either by entering an in-/outpoint
manually or by using the button SLIP SOURCE
KC (see section “Slip source KC…” on
page 8-48). Only the keycode’s reference num-
ber can be altered. When changing one of the
values, the remaining value will be set accord-
ingly, i.e. the duration will not be changed. Al-
tered values will be displayed in orange.
Destination IN
Destination OUT
These settings detail the destination in- and
outpoint either in timecode or in frames, de-
pending on the selected notation for the Edit
Tool (see section “About Timecode / Frame
Number Fields” on page 2-17). Usually they
determine the final position of the event on a
built-up timeline. They can be changed by alter-
ing the clips’ representations of a built-up EDL
in the timeline. Altered values will be displayed
in orange.
Duration Specifies the duration of the event (i.e. its
length) either in timecode or in frames, depend-
ing on the selected notation for the Edit Tool
(see section “About Timecode / Frame Number
Fields” on page 2-17).
TL status Indicates the timeline status of the event, i.e.
the track (audio (A) or video (V)) and track
number where the event can be found in the
timeline.
Source type Details the source/search type that was selected
during an autoconforming (see section “Con-
forming” on page 8-13). It is the same setting
as the Source type setting of the autocon-
forming dialog. By changing this entry you can
change the conforming (linking) method manu-
ally for the respective event. It will be applied
when the button LINK DATA… is used (see sec-
tion “Link data…” on page 8-50). In addition
to the settings already described in section
“Configuring the Autoconforming” on
page 8-15 you can select here the following:
Column Description