User guide

8-17
The Conforming Tool
2
1
3
4
5
6
7
8
I
A
9
The setting SpycerNet utilizes the SpycerNet
to search for clips. Its main advantage is that
you can include remote systems with it in your
search, but it may also be helpful during local
searches, especially when large amounts of
data should be searched through (faster
search). Once this setting is selected, the but-
ton to the right of the combo box Source type
will be available ( ). With it you can select
hosts and directories in the SpycerNet that
should be searched for the clips (including all
subdirectories).
With the setting VTR-TL you can select a VTR
timeline project for the conforming (see the
“CLIPSTER I/O Tool” user guide), i.e. the clips
on the 24-hours timeline of the selected VTR
project (Video path and Audio path) will be
used.
Video path Available for Disk Online and VTR-TL: De-
termines where to search for video clips. Either
enter a directory path directly or use the button
to the right ( ) to select the location. With
VTR-TL selected, this entry must point to a
VTR timeline project file (*.cp), i.e. the same
that is set for audio.
Audio path Available for Disk Online and VTR-TL: De-
termines where to search for audio clips. Either
enter a directory path directly or use the button
to the right ( ) to select the location. With
VTR-TL selected, this entry must point to a
VTR timeline project file (*.cp), i.e. the same
that is set for video.
Source searching
mode
Sets the mode that should be used for the
search. You can select between different search
modes:
Standard is the fastest search mode available
because it uses an efficient algorithm. Howev-
er, under rare circumstances it may not be able
to find the correct clips.
If the standard search does not yield the ex-
pected results, you can use an Intensive
search. It will look through the found files one
by one and thus takes considerably longer.