User guide

6-88
CLIPSTER Edit Tool User Guide
6.7.4 Finalizing
The buttons at the bottom right-hand side of the window ’Finalizing’
allow you to control this window:
6.7.5 The Finalized Output (Files per Folder)
The result (output) of a finalizing depends to some extent on the setting
of the Files per folder items. They allow you to configure the number
of files that will be stored in one directory.
Figure 6-73: The files per folder items
By default the files per folder items are set to 20,000 frames because
this is an appropriate value for the file system of the operating system.
Values below 1,000 files cannot be set. By activating the Unlimited
setting no further subdirectories will be created and the rendered files
will all be stored in the first generated subdirectory as described below.
With the files per folder items set to 20,000 our examples given in sec-
tion “Configuring Video” on page 6-82 and section “Configuring Au-
Use the button RENDER to start the finalizing pro-
cess. It will be available as soon as the necessary in-
formation are set, such as output type, storage
information and format.
Then the ’Finalizing’ window will be closed and
the tool area of the DVS software will switch to the
job list automatically (see section “Jobs” on
page 4-33). Additionally, the state of the rendering
process will be indicated by a progress bar. As soon
as it reaches 100 %, the process will be finished
and the window with the progress bar will be
closed. You can then access the generated clip(s)
on your storage.
With the button CLOSE you can close the ’Finaliz-
ing’ window without starting a rendering process.
You will then return to the main window of the
DVS software. However, already made settings in
the ’Finalizing’ window will be stored.
Windows may cause problems if more than 20,000 files are
stored in one directory.
Use the Unlimited setting only when you are sure that your
rendering causes less than 20,000 frames.