User guide

6-17
The Timeline
2
1
3
4
7
6
5
8
9
I
A
of the downmixed stereo clip will be provided. If the channels are
set to stereo, a standard stereo signal will be output.
Once the settings for the respective track are set, confirm and activate
them with the button OK of the audio track properties window.
6.2.7 Further Audio Configurations
Via the SETTINGS… button you can configure the an-
alog audio outputs to monitor audio during your work
with the software. It is located at the top left side of the timeline area.
After pressing this button the ’Timeline output settings’ window is
displayed.
At the bottom of this window you can find the Options area where
further optional settings are provided. To the right you can find the set-
tings items for a further configuration of audio:
Audio Clip
Audio
Track
Output
+ Button Channel A Channel B
Stereo Stereo Mono
(button
deactivated)
Mono of
stereo clip
Mono of
stereo clip
Stereo Stereo Stereo
(button
activated)
Channel 1
(left) of
stereo clip
Channel 2
(right) of
stereo clip
Audio will be given out via AES/EBU and embedded in the vid-
eo signal simultaneously.
Via the SETTINGS… button in the timeline area of the Edit Tool
(see section “How to Configure the Video Output” on
page 6-12) you can configure the analog audio outputs (see
section “Further Audio Configurations” on page 6-17) and the
maximum amount of audio channels that will be embedded in
the video signal.
The other items available in the Options area are explained in
their respective sections (see section “Changing the Layout of
the Timeline Area” on page 6-6, section “Loading and Apply-
ing a 3D LUT File” on page 6-18, section “Cropping the Time-
line” on page 6-21, and section “Burn-in Information at the
Output(s)” on page 6-25).