User guide

6-4
CLIPSTER Edit Tool User Guide
line as described in section “Changing In- and Outpoints of Timeline El-
ements” on page 6-47.
6.1.2 Taking a Clip from the Control Area
When a clip from the bin is dragged to the control area, the source-edit
mode is activated where you can set the in- and outpoint of the clip
frame accurately.
When the in- and outpoint are set as desired, perform the following:
y Select the bin clip in its video overlay and drag and drop it to a
video or audio track of the timeline.
If more than one clip is selected for the drag-and-drop proce-
dure, the Edit Tool will either align the clips horizontally in one
track of the timeline or put each clip into another track directly
below the selected one. This drag-and-drop behavior can be
configured with the Configuration Tool (see “CLIPSTER Con-
figurations” user guide for more information).
If you drag an audio clip to the timeline that contains more
than one mono or stereo channel (multiple channels), the ad-
ditional channels will be added to the other audio tracks below
the selected one.
Further information about the source-edit mode and how to
set in- and outpoint for a clip there can be found in section
“The Source-Edit Mode” on page 5-14.
Video clips can only be dragged to the video track(s) of the Edit
Tool and audio clips only to the audio tracks.