User guide

4-47
The Tool Area
2
1
3
4
6
5
7
8
9
I
A
If drops occur, they will be entered in the drop table of the performance
monitor and red bars will appear in the chart. Then please proceed as
follows:
y Check the position of the drops on the video timeline by double-
clicking entries individually or by selecting the MARK ALL button of
the table controls.
y Afterwards perform the play-out operation and the checking of the
drop positions again.
y Then compare the results and confront them with the following
table:
Marker
Position
Timeline
Element
Probable Cause Solution
At certain
position(s)
On video clip(s)
or transitions
Material at certain
frames faulty
Check the material on the storage and
replace the faulty files. After this the
problem should be resolved.
At random Within certain
video clips
The material has a res-
olution that is too high
Finalize the timeline to a format that
can be handled in real time (see sec-
tion “Finalizing the Timeline” on
page 6-80). After this the problem
should be resolved.
The storage location is
not real-time capable
Move the material to a real-time capa-
ble storage.
The storage location
where the material is
stored is too full
It is recommended to use only 85 %
of the overall storage capacity. If the
storage is too full, delete some of the
data.
On transition(s) Timeline material has a
resolution that is too
high for two simulta-
neous video streams
If the respective transitions are dis-
played in the timeline without a prer-
endering indication, reduce the value
that indicates when a timeline element
has to be prerendered (see Configura-
tion Tool in the “CLIPSTER Configura-
tions” user guide). Then prerender the
transitions (see section “Prerendering
of Timeline Elements” on page 6-46).
After this the problem should be re-
solved.