User guide

Viz Engine Administrator’s Guide

1. Select a configuration entry from the Configurations list, and click the Delete

button.

2. Click Save.

To manually activate an audio device

1. Open the configuration file.

2. Go to SECTION AUDIO_CONFIG and locate the Available0 setting.

3. Activate the identified audio device (Available0) by adding its name to the

AudioDevice0 setting.

• For multiple outputs, more than one device can be added as AudioDevice1,

AudioDevice2 and so on; however, this is not very common.

4. Save the configuration file.

Example: AudioDevice0 = Realtek HD Audio output

5.3 Authentication

The Authentication panel is for the authentication of one or more Viz One products on

Viz Artist. Enter the details of each Viz One product to connect to.

All three panels (Host Info, Realm and User Info) of the Authentication panel must be

completed to save a new User (if a Realm is not required type <empty> in the Realm

panel). If only one or two panels are completed then the information will not be saved:

• Host Info: The host name of the Viz One server

Note: The host info is in the form ‘host:port’, where the : sign and the port

number is optional. A single value of * shows that it should be used against all

hosts. The host info is not just the Viz One host name, it could also be the ip-

address.

Example: Host Info = hostname[:port] or ip-address[:port] or ‘*’

• A Host can not be added without at least one Realm (or an empty Realm with

<empty> entered) and one User defined

• A Host can have more than one Realm.

• Realm: Used to determine whether this entry should be used in an authentication

process for a given URI

Example: A single value of * shows that it should be used against all

realms,i.e., Realm = [a-zA-Z_0-9]* or ‘*’

• A Realm can not be added to a Host without at least one User defined

• A Realm can have more than one User.