User guide

Viz Engine Administrator’s Guide

• Click on the Quit button (top right menu)

• Press <double-Esc>, or

• Press <Alt+Q>, or

• Press <Alt+F4>

2. In the Do you want to quit or restart? panel:

• Click OK to Quit (Quit (close) is the default option), or

• Click on the drop down arrow to open the Quit or Restart menu

3. In the Quit or Restart menu, select from the available options.

4. Click OK or Cancel.

See Also

• Installing the Viz Engine

• Configuring Viz

4.1 Viz Command Line Options

The table below describes all the available Viz command line options

Viz command line options

Command Description

-3D If you want to playout 3D Stereo Clips, you need to start Viz

Engine with the -3D parameter. This sets Viz Engine in a special

mode where a side by side clip will be split and played out on

channel A and B on the Matrox board.Note that this is for clips

only!

-c Starts Viz in Viz Config mode. If you have two graphics cards you

can add an additional command for GPU 1 or 2 (e.g. -n -u1 or -

n -u2).