User guide

Viz Engine Administrator’s Guide

3. Click on Start > Run

4. Enter regsvr32 MatroskaSplitter.ax.

5. Click OK. A message box appears confirming your registration

6. Click OK

To unregister the Matroska Splitter

1. Click on Start > Run

2. Enter regsvr32 -u MatroskaSplitter.ax.

3. Click OK. A message box appears confirming that it is unregistered

To configure preview of clips stored on Viz One

If you installed the Viz Engine VGA version, please perform the following steps:

1. Open Windows Explorer

2. Open the Viz Engine configuration file

C:\Program Files (x86)\vizrt\Viz3

3. Locate SECTION TARGA3200

4. Set vizlink_mode = 1

5. Save the file

If you installed the Viz Engine Video version, please perform the following steps:

1. Start Viz Config

2. Select the Video Board section and enable (On) the Viz Link option

3. Click Save