User guide

Viz Engine Administrator’s Guide

21.9 Pinnacle Targa 3200

Pinnacle Targa 3200 was Vizrt’s standard card for SD Viz systems until 2007, and was

typically used with IBM ZPro 6221, IBM Z-Pro 6223 and HP xw8200.

Configuration History

• Driver - CODI v2.42

• Revision - 3213. Revision 3213 crashes the machine when used with CODI

v2.41rc13.

• Driver - CODI v2.41rc13

• Revision - 3212, 3214. Installation of CODI Compatibility Patch for revision 3214

is no more required.

• Driver - CODI v2.42

• Revision - 3212, 3213, 3214. Installation of CODI Compatibility Patch is required.

• Driver - CODI v2.2 RC4

• Revision - 3212, 3213.

See Also

• Matrox X.mio Series

21.10 LPT Controller for a Viz License Dongle

Exsys EX-41011 LPT Controller

To provide recent render engines of type HP xw8600 with support for parallel dongles,

an additional LPT controller card needs to be installed in the machine. For this purpose

the topmost 32bit PCI slot should be used.

To install an LPT controller card

Adding the LPT controller card will enable Viz to read the license from a parallel port

dongle.

1. Power down the system and prepare it for hardware installation as documented in

the manufacturer’s manual(s).

2. Install the controller in the xw8600’s topmost standard PCI (32bit) slot.

3. Turn on the machine.

4. After the operating system has started up, insert the LPT controller driver disk and

install as denoted in the manufacturer’s documentation.