User guide

Viz Engine Administrator’s Guide
Copyright © 2014 Vizrt Page 323
12. CVBS OUT: MCX connector for a composite video burst signal, either analogue
output of SD video or used for synchronization purposes.
13. GPI: Flat cable connector for the general purpose interface.
14. RS-422: Flat cable connector for an in- and output of RS-422 signals
15. AUDIO 1-8/LTC: Flat cable connector for the digital audio channels 1 to 8 and
LTC.
DIP switch
1. DIP Switch for Flash Controller: This switch controls the operation of the on-
board Flash controller; it defines the version set of the map file that will be loaded
at startup. The image above depicts the default setting of the DIP switch for the
Flash controller; please observe the orientation of the switch on the card.
2. Audio 9-16: Flat cable connector for the digital audio channels 9 to 16.
3. Breaking line: The printed circuit board provides at its bottom (PCIe variant only)
and right side extensions void of any electrical parts; these may serve to stabilize
the installation of the card in a computer system; when not needed or interfering,
you can break them off the circuit board at the breaking line(s); see also dotted
lines in figure 1 on the previous page.
Description of the LEDs on the video card
LED Function Mode Description
Green Signals the
status of the
sync input
On A correct sync signal is detected, that is:
- Sync mode internal is set
- Sync mode external is set and a correct signal is
connected
- Sync mode analog is set and an analog GenLock
signal is connected
- Sync mode digital is set and a correct signal is
connected
Off A wrong input signal is detected, i.e.:
- Sync mode external is set and no SDI input
signal.
– Sync mode analog is set and no GenLock signal
connected.
– Sync mode digital is set and no SDI input signal.
Red Signals the
status of the
video raster
detection
feature
Blinking
slowly
No input signal is available