User guide

Viz Engine Administrator’s Guide
Copyright © 2014 Vizrt Page 307
Once the machine is powered up you may verify that the Matrox X.mio board has been
correctly installed by looking for the blue OB -light on the (top) backside of the slot
panel. A lit light indicates that the board is correctly supplied with power.
See Also
• Matrox X.mio Series
• Replace a Matrox X.mio Series Board
• Connect a Matrox X.mio Series Audio-extension Card
• NVIDIA Graphics Cards
20.9 Replace a Matrox X.mio Series Board
To replace a video board
This procedure describes how to safely remove a video board driver from a system with
an existing video board, or a system that previously has had a video board installed.
1. Remove the video board drivers.
2. Shut down the machine.
3. Install the replacement video board.
4. Install the video board drivers.
IMPORTANT! When changing a Matrox video board the Matrox.Devices setting,
set in the configuration file’s SECTION MATROX_CONFIG, will not be updated. The
Matrox support will not be correct and the new board will not work. In this case the
setting must be removed and Viz Engine restarted such that Viz Engine can insert
the new serial number.
See Also
• Matrox X.mio Series
20.10 Connect a Matrox X.mio Series Audio-extension Card
Matrox X.mio and X.mio2 has support for audio-extension cards. Such a card is installed
when AES / EBU audio support is required.
IMPORTANT! The Matrox audio-extension card only supports digital audio.
To connect the audio-extension card to the video board
Connecting the audio-extension card to the video board.
1. Locate the connectors on the audio-extension card labeled A and B.